How to Mount an Air Cooler Evaporative

By using the mechanism of water evaporation, evaporative coolers operate under the theory of heat absorption. By drawing hot air from the environment onto the wet sheets, the machine works. With the assistance of the fan, the cool air produced is circulated into rooms.

Many individuals mount their coolers on the ceiling and repair blowers that drive the air into a discharge cooler. It is cheaper to mount the unit on the roof top, but it has many drawbacks. Some of the pitfalls include getting on the roof to service the machine, leaks in the ceiling and deterioration of the system constructed to hold the cooler.

Make sure you check the area's building codes before you add an evaporative cooler. You must settle on the location and identify the opening after you have tested the codes. Then you must build an iron or wood framework and connect the platform to the opening. Make sure you don't cut any structural structure when repairing the platform. The size of the opening and the layout will depend on the manuals that the computer comes with.

You have to rent equipment that will position the cooler on the platform until the platform has been fixed. You can recruit a few people to lift the cooler and position it on the platform if you've ordered a huge cooler. To check the separators that can be used between the cooler and the platform, read the instruction manual that comes with the cooler. Supporting the computer with man wires is a smart idea to stop winds destroying the machine.

To attach the computer to the water supply, check the size of the water tube that you will require. To attach the tube to the water source, you should use the saddle valve since it will guarantee an uninterrupted supply of low volume water to the cooler. You must link the electric wires to the power supply with the aid of the proper conduits after attaching the cable. To figure out whether you should do the wiring or if you have to employ a contractor, search the city codes.

You must attach the motor and change the tension of the belt if you have brought in a new device. The motor is normally connected when you buy an old unit, and you have to make minor changes to the fan belt. Once the fan belt and the engine are fixed, you must ensure that the vents are open and that the ducting is properly built. Turn the water on now and set the water by making the float valve changes. You can start the cooler after all the connections are tested and change the vents to get the desired air flow.